Skip to main content

How to play sound file automatically when no mask detected from the AI camera?

  • Updated

Applies to Models:  Zenitel Intercoms

Summary:

Playback a sound file from AI camera when no mask is detected

 

Step By Step Guide:

1)  For the manual audio playback, you need to upload an audio file and configure the settings in the intercoms.

The audio file must be in Wav format, and the following codecs are supported:

  • PCM files at 16kHz sample rate (linear 16bit), mono (1 channel)
  • MS ADPCM at 16kHz sampler ate, mono (1 channel)
  • IMA ADPCM at 16kHz sample rate, mono (1 channel)

2) To upload and set up, you need to activate the advanced configuration mode from the intercom’s web interface.

    a)  Click on the Recovery tab under the Main

    b)  Type in the password, 1851, in the Advanced configuration mode, located at the bottom

    c)  Click on the box and then press on the save box

 

mceclip0.png

 

3) To upload the audio file from the intercom's web setting

    a) Click on the Audio Messages tab from the SIP configuration (Edge configuration in the Edge mode)

    b) Click on the Choose File box, browse to the audio file, and then press the Upload button

    c) Select the uploaded audio file for one of the message slots, set the event to Relay,

        select one of the outputs (output 3 selected for this example), set it to On, and set it to Speaker

 

mceclip1.png

 

4) Change the I/O setting from input to output. Select the I/O tab, and change the input to output for the I/O number that you have defined from step #3. Click on the Save button

 

mceclip2.png

 

5) Create an event to action in WAVE

Event

When:  Analytics Event

At:  Select an AI camera

Event Type: No Mask

 

Action

Do:  Do HTTP request

HTTP URL:  http://192.168.1.4/goform/zForm_webcall?activate=Activate&relaytimer=1&relayId=output3&username=admin&password=alphaadmin

 

192.168.1.4 : Replace it with your intercom’s IP address

relayId=output3 : Replace it with the output that you have defined in the intercom

Username : Replace it with your intercom’s user name, if changed from the default

Password : Replace it with your password for the intercom user

 

Click on the Save button

 

 

 

Related articles