Applies to Models: All Hanwha Vision America IP cameras, encoders, decoders

Summary:

This article will walk you through assigning IPs to multiple cameras at once via Wisenet Device Manager.

NOTE: When two or more cameras, encoders, decoders, etc., are on the same IP address,
you will not be able to register them into an NVR; you also will not be able to 
log in via a web browser.

Step By Step Guide:

1. Download Wisenet Device Manager and its manual from >Here<

2. Install Wisenet Device Manager

3. Make sure your PC's network card has an IP address assigned to it

4. Click the Search button in the upper-right part of the screen (Figure 1)

NOTE: If search returns no results, try using the article >Here< to diagnose
the search issues

Figure 1

5. The found devices will appear in the open window area (Figure 2)

6. Devices that are successfully logged into will have a green checkmark, ones that are not will have a grey question mark (Figure 2)

Figure 2

7. Click Ctrl+A to select all of the devices at once; they will become highlighted (Figure 3)

8. The Status column should say Need PW (Figure 3)

Figure 3

9. Click on Credential (Figure 4)

Figure 4

10. Enter your Password, and Confirm your Password (Figure 5)

11. Click Apply (Figure 5)

Figure 5

12. The Result column should say Success (Figure 6)

Figure 6

13. With the camera still selected, click IP Assign (Figure 7)

Figure 7

14. When there are multiple cameras, you put in the starting IP (Figure 8)

15. Click Simulate (Figure 9)

Figure 9

16. Click Apply (Figure 10)

17. The Result column should say Success (Figure 10)

Figure 10