Applies to Models: Hanwha Vision America cameras, encoder, decoders

To maintain standards, Hanwha Vision America uses the web UI for all knowledge base articles about product configuration. Open Chrome, enter the IP Address of your device into the URL bar, and press enter. If you are not using the web UI to configure your device, please refer to the user manual for your product.

Summary:

The default IP address for all Hanwha cameras is:

192.168.1.100

The default IP address for all Hanwha encoders and decoders is:

192.168.1.200

Step By Step Guide:

1. When you power up the camera with a PoE injector or PoE switch without DHCP running, the camera in question will be at IP: 192.168.1.100

2.  When you power up the encoder or decoder with a power supply, PoE injector or PoE switch without DHCP running, the encoder or decoder will be at IP:  192.168.1.200

NOTE: Since our devices ship in DHCP mode, if our products are placed on a
network with a functioning DHCP server, the device will obtain an IP from 
that server upon bootup completion.

2. Type the IP into the URL bar of your browser, then press enter