Applies to Models: XND-8081REV, XND-8081RE, XNV-6081REV, XNV-6081RE
Summary:
Below is a short video explaining the basics of using our PoE extender cameras to two devices at once.
Video:
Step By Step Guide:
- Plug in a network-connected ethernet cable to the PoE+ ethernet port.
- Wait until the network light on the camera's ethernet ports comes on. (0:14)
Note: This confirms an active connection between the camera and the network
- Prepare another Device for installation.
- Plug an ethernet cable into the PoE pass-through port on the first camera.
Note: The Port is Labeled PoE out.
- Connect the ethernet cable to your second camera's ethernet port.
Note: If you are using a second PoE extender camera, repeat this process.