Applies to Models: XRN-3010, XRN-3010A, XRN-3210, PRN-3210, XRN-6410, PRN-6400
To maintain standards, Hanwha Vision uses the web UI for all knowledge base articles about product configuration. Open Chrome, enter the IP Address of your device into the URL bar, and press enter. If you are not using the web UI to configure your device, please refer to the user manual for your product.
Summary:
Hanwha Vision NVR's with Distributed recording ability can effectively double their bandwidth by setting up two or more recording channels to increase streaming throughput.
Step By Step Guide:
1. Open Chrome
2. Enter the IP of the NVR into the URL bar of Chrome
3. Press Enter
4. Enter the admin credentials to log into the NVR
5. Go into the Setup on the NVR
6. Go to Device>Storage Device (Figure 1)
7. Select the Distributed Recording option (Figure 1)
8. Put the radio switch from Continuous Recording to Distributed Recording
9. Click Initialize (Figure 1)
Note: Newer and Legacy recorders will automatically configure a distributed
array.
Figure 1
Note: Figure 1 is asking me to check drive 2 because my NVR does not have a
second drive
10. Click Apply