Encoder - SPE-410 changing NTSC to PAL

The Network Video Encoder SPE-410 supports NTSC and PAL video sources at standard resolutions.

However, the modes have to be changed manually using a CGI command.

The procedure to change the encoder to PAL mode is as follow:

1. Connect to the encoder using a standard web browser
2. Log in to the encoder
3. Paste the CGI command below in to the address bar (change <ipaddr> to actual IP address)
   • http://<ipaddr>/stw-cgi/factory.cgi?model=SPE-410&lang=0&vt=1
4. After sending the CGI command, a "OK" should appear on the web page.
5. Now reboot the encoder and test using a PAL source.

The CGI command also lets you change back to NTSC by editing the variables listed below.

• lang: 0(ENG) , 1(CHN), 2(KOR)  ---Language
• vt 0(NTSC) , 1(PAL)                     ---Video Standards