Applies to Models: WRN series NVRs

Summary

The NVR runs on the Ubuntu Linux Operating System and has a different procedure for preparing storage than a Windows PC. This article provides instructions for adding storage capacity to a WRN series NVR. 

Adding Storage

To add additional storage to a WRN series NVR:

NOTE: The images in this article are from a WRN-810s which only has two drive slots. 

1. Remove the screws for the top case and remove the casing so you can see inside the unit.
   
   
   

   NOTE: Refer to the instructions in the Wave PoE NVR manual.

2. Use the included screws from your drive manufacturer to physically mount the drive.
   
   
   
   
3. Connect the power and data cables to the new drive.
   
   

NOTE: For how to properly mount this drive in Linux, refer the the following 
article: Why doesn't my hard drive appear in my Linux based WAVE Server?