Applies to Models: All Analog cameras that are not PTZ units. PTZ units use a special CVBS dongle (included in the box)

Summary:

At times there may be a need to switch a camera's resolution from AHD to composite. This article details the steps required to change the resolution of our legacy analog cameras. 

Note: All Hanwha Analog cameras are set to AHD by default

Step By Step Guide:

1. Locate the Function Setup Switch on the rear of the analog camera. This switch is a directional pad and also presses directly in

2. Press and Hold in the Function Setup switch for 10 seconds. (See the below images for the location of the Function Setup switch)

Note: To restore the AHD settings, repeat Step 2

Figure 1 SCB

Figure 2 SCO

Figure 3 SCD & SCV