Applies to Models: SNH-V6435DN
To get you started with your doorbell, please follow the steps below.
1. See the list of compatible chimes.
[Caution] Make sure to check your chime type. (Mechanical/Electrical/No chime )
2. Connect the Power Stabilizer Kit to your existing mechanical/electrical chime.
When you install Smartcam D1, make sure to install Power Stabilizer together with the existing chime. If Power Stabilizer is not installed, it may not work properly.
3. Install the doorbell.
4. Download the Wisenet SmartCam+ app for app setup.
[Caution] You must know what type of your chime is. (This should be mentioned in the earlier steps. See above for revised sentence)
It may get damaged if you connect transformer only and set for 'mechanical' or 'electric' without having an actual chime.
The SmartCam D1 may get damaged if you only connect the transformer and set the doorbell chime type to "mechanical" or electrical without an actual chime.
5. Once app setup is complete, , attached the faceplate back on, tighten a secure screw.